
Elk Grove Repiping: Whole House Repiping and Slab Leak Repair in Elk Grove, CA
Elk Grove Repiping does whole house repiping in Elk Grove, CA, including Laguna, Laguna West, and the neighborhoods off Elk Grove Boulevard and Bond Road. We tear out failing polybutylene, Kitec, copper, and galvanized water lines and run new PEX or copper to every fixture. We also fix slab leaks, find hidden leaks, replace main water lines, and close up the walls when the job passes inspection.
Monday to Saturday, 7:00 AM to 7:00 PM
Get a Free Repipe Quote
What does a whole house repipe include?
A whole house repipe swaps out all of the water supply piping in your home. We start at the main shutoff and run new hot and cold lines to every sink, shower, tub, toilet, washer box, ice maker, water heater, and hose bib. Every fixture gets a new stub-out and a new shutoff valve.
Your drains stay put. Drain, waste, and vent pipes are a separate system that carries water out of the house. A repipe deals with the pressurized side, the water coming in.
Here's the order we work in on a typical Elk Grove house:
- We find the main shutoff, check your water pressure, and look at the pipe we can see in the garage, attic, and under sinks.
- We map out a route for the new lines through the attic or walls so most of the work stays out of your living space.
- You get a written price, and we file the permit with the City of Elk Grove.
- We lay down floor protection, cover furniture, and cut small openings in the drywall only where we need to reach the pipe.
- We run the new lines, tie in each fixture, and pressure test everything before the walls close.
- The city inspector signs off. Then we patch and texture every opening we made.
Why do so many Elk Grove homes need new pipe?
It comes down to when the houses went up. Elk Grove was a farm town for most of its history. Then the subdivisions came, and they came fast.
Elk Grove incorporated as a city in 2000. City Manager Jason Behrmann told Comstock's that much of Elk Grove was built out before that, with Sacramento County developing residential subdivisions in the 1980s and 1990s.
Those two decades line up with two pipe products that caused a lot of trouble. Polybutylene, the gray plastic pipe, was sold from the late 1970s into the mid 1990s. Kitec, the orange and blue pipe with brass fittings, was sold from 1995 until 2007. A house built in Laguna in 1988 or in East Franklin in 2004 could have either one. Copper homes from the same years are now 20 to 40 years old, and that's about when pinhole leaks start showing up.
Here's what we usually find:
- 1980s and early 1990s tracts: gray polybutylene lines, often with plastic or copper crimp fittings. This pipe gets brittle and cracks with age.
- Late 1990s through the mid 2000s: some homes got Kitec. The brass fittings corrode from the inside and the lines can burst.
- Copper homes of any age: pinhole leaks, green crust at the joints, and water spots on ceilings.
- Older homes near Old Town Elk Grove and on rural lots: some still have galvanized steel that rusts shut and drops your pressure.
Want to check your own house? Look at the pipe coming out of the top of your water heater. Gray plastic is often polybutylene. Bright orange and blue pipe with brass fittings stamped "Kitec" or "KTC" is Kitec. Copper is shiny or dull brown metal. Dull gray steel with threaded joints is galvanized. Red, blue, or white tubing is usually newer PEX.
What is Elk Grove's water like?
Most of Elk Grove gets water from the Sacramento County Water Agency. Part of the city is served by the Elk Grove Water District instead, which runs its own wells and also buys water from the county agency for part of its area. Your bill tells you which one you have.
The Sacramento County Water Agency's 2025 report for its Central and South Service Area, which covers Elk Grove and Laguna, lists treated surface water hardness at 47 to 62 parts per million, averaging 55. Groundwater ranged from 9.1 to 160 parts per million, averaging 44. The same report classifies 0 to 60 parts per million as soft and 61 to 120 as moderately hard.
Source: SCWA 2025 Water Quality Report, Central and South Service Area
So on average, Elk Grove water is soft, but some wells run harder than others. That's why the scale in one water heater can look nothing like the scale in a house two miles away. Water chemistry is one piece. Pipe material, age, pressure, and install quality matter more. When we look at a house, we judge the pipe in front of us.
What pipe do we install?
PEX goes into most of our jobs. Copper is still an option if you want it. Here's the quick version:
| Pipe | What it is | What to know |
|---|---|---|
| PEX-A | Cross-linked plastic tubing, joined with expansion fittings | The most flexible type. It bends around framing and the fittings don't shrink the opening. |
| PEX-B | Cross-linked plastic tubing, joined with crimp or clamp rings | A bit stiffer and a bit cheaper than PEX-A. |
| Copper Type L | Copper with a thicker wall | Long track record, higher price. |
| Copper Type M | Copper with a thinner wall | Common in homes, costs less than Type L. |
PEX comes in long coils, so a single run can go from the water heater to an upstairs bathroom with no joints in the wall. Fewer fittings means fewer places to leak and less labor, which is why PEX usually costs less to install than copper. Our PEX vs. copper guide goes deeper.
What services does Elk Grove Repiping offer?
Our work is water lines and the leaks that come with them. We don't do drain cleaning or fixture installs.
PEX Repiping
New PEX to every fixture, with or without a manifold.
PEX RepipingCopper Repiping
Type L or Type M copper for homeowners who want metal.
Copper RepipingGalvanized Pipe Replacement
Rusted steel lines out, full flow back.
Galvanized Pipe ReplacementPolybutylene Pipe Replacement
Gray plastic pipe from the 1980s and early 1990s taken out before it cracks.
Polybutylene Pipe ReplacementKitec Pipe Replacement
Orange and blue Kitec lines and brass fittings replaced.
Kitec Pipe ReplacementPartial Repipe
One bathroom, the kitchen, or one bad stretch of pipe.
Partial RepipeSlab Leak Repair
Leaks under the concrete fixed by reroute or a spot repair.
Slab Leak RepairLeak Detection
Finding the leak before anything gets opened up.
Leak DetectionWater Line Replacement
The line between your meter and the house.
Water Line Replacement
How much does a whole house repipe cost in Elk Grove?
Every house prices out a little differently. These are the biggest things that move the number:
- Number of bathrooms and fixtures
- One story or two
- How much room there is to work in the attic
- Slab foundation or raised floor
- PEX or copper
- Whether the main line from the meter is part of the job
- How many drywall openings need patching
For a national starting point, Angi's 2026 cost data puts the average repipe at about $7,500, with most jobs falling between $1,500 and $15,000. Those are national figures, not our prices. Big two-story homes and copper jobs land on the higher end. See the Elk Grove repipe cost guide for the full breakdown.
How long does a repipe take?
Most Elk Grove homes take one to three working days. A single-story house with an open attic is on the short end. A two-story house with three or four bathrooms takes longer.
You can live at home the whole time. The water will be off for parts of each day while we tie in, and we tell you the night before when to expect it. Floors and furniture stay covered, and we clean up before we leave each day. Drywall patching happens after the inspection. Our guide on what to expect during a repipe walks through it day by day.
Does a repipe in Elk Grove need a permit?
Yes. The City of Elk Grove's Building Safety and Inspection Division issues plumbing permits and inspects the work. The city lets contractors pull a short list of minor permits online, like water heater changeouts and water line repairs. A whole house repipe isn't on that list, so it goes through a regular permit application, and the city requires those to be submitted electronically.
We file it, schedule the inspection, and meet the inspector. Our Elk Grove repipe permits guide has the details, including the smoke alarm rule that can come with residential permits.
Do you fix slab leaks too?
Yes. Not every call is a full repipe. A warm spot on the floor, a water bill that doubled, or the sound of water running with every tap shut off can all mean a leak you can't see.
We start with leak detection to find it. If it's under the concrete, slab leak repair fixes it, either by opening the slab at that spot or by rerouting the line through the attic. If the leak is in the yard between the meter and the house, that's water line replacement and repair.
Where does Elk Grove Repiping work?
We cover all of Elk Grove, including Laguna, Laguna West, East Franklin, and Old Town, plus these nearby areas:
- Repiping in Sacramento
- Repiping in Galt
- Repiping in Vineyard
- Repiping in Florin
- Repiping in Wilton
- Repiping in Rancho Cordova
Don't see your street? Check all service areas or give us a call.
Repipe guides for Elk Grove homeowners
- What a repipe costs in Elk Grove
- PEX vs. copper for your repipe
- Signs you need a repipe
- What to expect during a repipe
- Slab leak repair options
- Repipe permits in Elk Grove
Whole house repiping FAQs
How can I tell if my house needs a whole house repipe?
Two or more leaks in a year, brown or rusty water, weak pressure at more than one faucet, or polybutylene or Kitec pipe in the house are the usual signs. One pinhole leak in copper is a good reason to have the rest checked.
Will you have to open up a lot of walls?
No. Most of the pipe runs through the attic. We make small openings where lines drop down to fixtures and patch them after the inspection.
Is PEX allowed in California homes?
Yes. California approved PEX for home water lines, and it's used on new homes and repipes all over Sacramento County.
Can I stay in the house during the repipe?
Yes. The water is off for part of each day while we connect lines, and we give you the schedule ahead of time.
Do you replace the water heater during a repipe?
We hook your water heater up to the new lines. Replacing the water heater itself is a separate job with its own permit.
Does a repipe include the drain lines?
No. A repipe covers the water supply lines. Drains and the sewer are a separate system.
Do I have Kitec pipe?
If your house was built between about 1995 and 2008 and you see bright orange and blue pipe with brass fittings stamped "Kitec" or "KTC," you likely do. Call us and we'll take a look.